| |
|
The Porter-Cable PIN100 1/2-Inch to 1-Inch 23-Gauge Pin Nailer takes care of all of your finishing projects, such as crown molding and other molding, and does it quickly and efficiently. It uses a dual trigger feature to fire the 23-gauge micro pin nails from the 170 pin bottom load magazine. This smart pin nailer even recognizes the length of the nail and automatically adjusts accordingly. The rubber comfort grip ensures hours of easy operation.
|
«
Porter Cable 23 gage Pin Nailer
»
I don't know how I got along without the neailer in the past. I have used it to secure the corners on several trophies that I had glued together. The trophies were made of ash, and the nailer had no trouble in securing the corners. The only thing I could complain about, I wish the nailer accomodated a pin nail 1 1/4 or 1 1/2 inch in length.
Rating: 
(5
out of 5) @ 2008-12-29
|
«
pin nailer
»
Porter-Cable PIN100 1/2-Inch to 1-Inch 23-Gauge Pin NailerI got this pin nailer because my wood working mentor had one. I use it to pin joints together while the glue dries. It saves a lot of time and I don't need as many clamps to do the job. If you read the instructions that come with the nailer you shouldn't have problems with it.
Rating:
(5
out of 5) @ 2008-12-16
|
«
good little gun
»
I read a lot of reviews for several different pin nailers. I have nothing negative to say about this gun. Works beautifully every time. Considering it is three times "Less expensive", you can't go wrong.
Rating:
(5
out of 5) @ 2008-10-20
|
«
Simply Amazing
»
I have had this nailer since April and has seen a lot of use and I must say this is an excellent nailer. If you think and 18g nailer leaves a small hole you would be amazed that these nails leave next to no visible mark. You truly have to see it to believe it. I have used this nailer for fine trim work on night stands, coffee tables and other furniture with amazing results. It goes through oak, hickory, ash, and brazilan walnut with no problems. I have also used it to put on quarter round with excellent results. I have shot over well 2000 nails with this without a single jam or misfire. This is an excellent nailer at a great price.
Rating:
(5
out of 5) @ 2008-09-10
|
«
SOLUTION TO SET THE PINS BELOW THE SURFACE!
»
you can shave the noze of the nailer with a grinder by taking off a 1/32 or even a 1/16. that should set the pins below the surface i've done it with several guns and it works just fine, just adjust the pressure if you have to!!!!!
Rating: 
(4
out of 5) @ 2008-05-26
|